F        . Put paper over PS42 in standby. Slid out the cassette. F    . Set it to UP position.
|Date Added:||8 March 2015|
|File Size:||43.38 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Then, generate the following to check the image front margin: Resolution – one of the main characteristics of the scanner. Mounting the Main Thermistor When mounting the main thermistor to the fixing assembly, be sure that the tie-wrap  is as shown.
Move the scanner by hand in standby. Close the 2 edge saddles. The light-blocking plate is not at PS1.
Canon Photocopier ImageRUNNER 105
Removing the BD Unit 1 Remove the stream read fan duct. F 3 Disconnect the connector , and remove the heater 3 screws ; then, detach the separation fan . Clean the sliding areas, and apply silicone oil FY Replace the developing roll.
Holding the grips front, rear on the delivery side of the copier, slide the copier down the slope imageruunner to move it off the skid. This, however, does not apply to counter 1, whose data cannot be changed. Be sure not to leave out the washer when assembling the machine. The result is a unique combination of speed,advanced digital features,and document-finishing capabilities that sets new benchmarks for the high-volume marketplace.
At pages per minute,the imageRUNNER brings Canon’s industry-leading technology to high-volume print-on-demand and acnon production environments. F     .
Pre-transfer charging assembly 8 Is the pre-transfer charging assembly fully fitted? F         End butted. The harness clip will divide into two during the work. Warranty Card English; V model only. Is the problem corrected?
Calaméo – imageRUNNER iR Parts and Service Manual
Be user to describe the check on the leakage breaker in the Service Book. Fixing assembly 5 Using the door switch actuator, make a copy with the front cover open.
Ccanon silicone oil S FY Paper is at PS At this time, check to make sure that the wire saddle  at the rear matches the marking  on the control panel harness. The No Web warning is absent. To protect against static charges, one of the mounting screws of the rear cover comes with a toothed washer. After adjustment, make sure that the distance between the paper face and ig105 A roller is 2. F 4 Remove the screw , and disconnect the 2 connectors ; then, detach the manual feed tray switch assembly .
Take full care whenever servicing areas of the machine behind these covers. Or, mark the position of the solenoid on the support plate with a scriber. F             . For both, mount the heater so that the side with the longer harness is to the front.
F           . Put paper over PS5 in standby.