Mobile, Alabama, United States View my complete profile. Or you can print out charts to carry with you on your next Observing run, which is what I used to do in the mid s with Deep Space 3D. In order for this to work, there are a few Autostar II handbox settings that must be made once:. Serial is very convenient for astronomy, since it allows long runs of cable, but you have to have a serial port on the computer to use it. Any questions, email me:
|Date Added:||8 January 2011|
|File Size:||53.25 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Adding the focuser requires going to a higher pin count PIC. This will also hopefully help anyone coming to similar situations later, as the problems and answers will not be interlaced.
Meade LX200GPS / R Telescope and Focuser Driver
Raw16 is selected and seems to be the default.
I have got the camera ZWO drivers installed and sharpcap can see it and will connect to it properly. All the info required to build this is on this web page and the source is available at a link for all hobbyists and non-commercial entities. In the latter state, all motors are off and the scope will not respond to commands from the handbox or the serial line.
The ST-4 interface supported by Meade telescopes is a 4 wire interface and provides a way to command the telescope to move in small increments based upon bringing asckm signal line low by an external piece of equipment. Tested and confirmed working software: This firmware upgrade alters the Smart Drive behavior, and existing PEC data must be converted to the new format.
I need to control my scope, my dome, and my auto – guide camera. For a long time, that was not the case with astronomy programs.
Create an account or sign in to comment You need to be a member in order autostat leave a comment Create an account Sign up for a new account in our community.
Using PHD Guiding
Sometimes you will find that when you go-to a target and center it up with the hand control, it is no longer centered under acom target cursor on the PC screen. When you want to use the scope again, depending on whether you left auotstar powered up or not, do one of the following:.
Hello Dear Michael, did it work? In addition, the base circuit board applies itself to standalone focusers and output to ST4 compatible scopes for guiding. While not complete functionality e.
Now you need to pair the serial Bluetooth adapter with your computer. The manufacturers of printers and cameras and scanners and other common devices write drivers that are recognized by the Operating System. Low torque full steps forward:. Update Update Nov 14, These units are in continuous stock, available to ship in 2 days or 5 days.